Painting & Sealing a Concrete Floor
Concrete decks and floors should be wire brushed and power-washed. In certain situations a shot-blaster may be needed to roughen the surface. Vacuum away any excess dust or debris. Read all label instructions before beginning. Always run a test patch first in an inconspicuous area to ensure that proper adhesion and drying occurs and the product works to your satisfaction.
Apply a coat of Ames® Super Primer™ (at the rate of 1 gal. / 200 sq ft.) to fill in cracks and increase adhesion to concrete. It will go on milky white and will dry clear in about 30 min. to an hour or so. It leaves a clear, slightly tacky surface that is ideal for coating. Then top coat with 2 coats of Ames'® Safe-T-Deck™.
Clean-up, Storage, and Disposal:
Clean tools and small spills with water only – do not use any soaps or detergents. Store unused product in its original container, tightly sealed and protected from freezing. Dispose of this product in accordance with local, state, or federal requirements.